Rockwell Automation Publication 1609-UM009D-EN-P - February 2021
11
1609-B Installation Instructions
1609-B Installation Instructions
Battery Wiring and
Installation
1.
To access the battery compartment, remove the three screws and the
battery door.
2.
Remove the battery container, jumpers, and wire harness from the battery
compartment.
3.
Place the battery container and batteries onto a flat surface.
4.
Use the provided jumper wires to connect the batteries in series.
–
Connect the positive terminal (red) of the battery to the negative
terminal (black) of another battery.
–
Connect the red wire of the harness to the positive terminal (top red)
and the black wire of the harness to the negative terminal (bottom
black).
ATTENTION:
Disconnect the 1609-SPD before servicing, due to electric shock
hazard for risk of severe injury or death.
IMPORTANT
The 1609-B UPS requires (2) 12V batteries, which are not included. See
for more information.
