Rockwell Automation 2711C-F2M, Quick Start Manual

Page: 95 / 110

Publication 2711C-QS001F-EN-P - November 2010 95
Validate and Run Application Chapter 9
Validate the Application
Before you can run an application on the PanelView Component, it is strongly recommended that you
validate the application for errors and warnings. The application does not need to be error-free to run,
however, it is good practice to fix both errors and warnings to ensure expected system behavior. Validation is
not supported in PVc DesignStation 2.0 .
1.
Click the Validate icon on
the application toolbar.
If the application passes
validation, the Validation
Results dialog looks like this.
If the application detects
warnings or errors, the
Validation Results dialog
might look like this. For
each warning or error, the
message identifies the
problem and its location.
Correct the problem and
then revalidate the
application.
The status bar shows a
Validation Reports link
that you can open. It
always shows the results
of the last validation.
2.
Click Close.
3. Click the Save icon to save
the application.
4.
Click the Close Application
icon to close the application.
ATTENTION
Running a non-validated application may result in
unexpected behavior.