Rockville RPG152K, User Manual

Page: 6 / 16

MASTER LEVEL
MIC LEVEL
3. Keep Master Level at 0 position.
4. Turn Mic Level to 0 position.
5. Switch on the Power Gig unit.
6. Slowly turn Mic Level clockwise until you achieve appropriate volume setting. This
is determined by the CLIP LED indicator light. Proper function is achieved when the
CLIP indicator lights up at peak levels, it should never be in constant on position.
7. The above adjustment matched the microphone preamp to the input volume of the
Power Gig unit.
8. Now turn up the Master Level to necessary loudness by rotating clockwise.
Always stand behind the Power Gig when making your microphone adjustments to avoid
feedback distortion.
You can choose to hook up two microphones to your Power Gig in the following manner.
Set up microphone #1 as instructed above. Using same set up instructions, insert
microphone #2 into the ultra-low noise Line input which features its own separate Level
control. Use this Level control to increase the microphone level and balance the inputs
between the two microphones before attempting to adjust the Master Level.
Multi-Microphone Hook Up
2
POWER
3 4
8
1
5
6 7
CLIP
OFF
ON
POWER
POWER
MASTER LEVEL
MIC INPUT
MIC LEVEL
You can use the Line Input function when you wish to hook up an additional stereo signal
source without the use of a mixer console. CD players, DVD music players, MP3 players
etc can be plugged directly in to the RCA inputs labeled LINE INPUT.
To connect a CD, DVD music player or MP3 player.
1. Turn your Power Gig unit to OFF position.
2. Turn Master Level to 0 position.
3. Turn Level control to 0 position.
4. Connect the music source unit to the RCA inputs marked Line Input.
5. Switch ON your Power Gig unit.
6. Slowly turn the Level control clockwise until the CLIP LED indicator begins
to blink, then turn it down slightly. This indicates the maximum input voltage gain is
matched and set properly.
7. Turn Master Level up to achieve proper volume.
Line Input Feature
Your Power Gig features an ultra-low noise Mic/Line inputs via XLR & 1/4
˝
TRS
stereo jacks.
1. Make sure the Power Gig is in OFF position.
2. Plug in your microphone.
APPLICATION USES
Microphone Presentations