Rockville ROCK PARTY 8, Owner'S Manual

Page: 6 / 12

4
Recording Microphone Input
The Rock Party 8 can record all microphone input to a USB drive. Simply press the REC
button on the remote control while using the microphone(s). To play back your recording,
press the REC PLAY button on the remote control. To delete the recording, press the
R-DEL button.
Operation
(continued)
USB/SD
The built-in media player allows you to play MP3 files. To access this function, follow the
steps below.
1. Make sure the speaker is ON.
2. Insert a USB flash drive or SD card into the corresponding port. Music should begin
playing automatically.
3. Use the PLAY/PAUSE button to pause and resume playback.
4. Use the PREVIOUS/NEXT buttons for track selection.
5. Use the master VOLUME knob to set the volume level.
Please note: The unit can accept SD cards and USB drives with a max capacity of 32GB.
Accepted formats are MP3, WMA, WAV, and FLAC.
You can connect two wired mics (not included) via the ¼˝ unbalanced MIC IN ports located
on the top of the unit. There is an independent mic volume control and an echo effect con-
trol on the remote. To connect wired mics, follow the procedure below.
1. Make sure the speaker is OFF.
2. Plug your microphone(s) into either of the ¼˝ mic inputs (MIC 1 or MIC 2).
3. Set the MIC VOL to the lowest setting.
4. Set the master VOLUME to the lowest setting.
5. Turn the speaker ON.
6. Slowly adjust the MIC VOL until you’ve reached the desired level.
7. Adjust the master VOLUME as needed.
Always stand behind the unit when using microphones so as to avoid feedback.
Microphone
2. Press the MODE button on the unit or the remote control until you are in Bluetooth
mode. The word “bLUE” will appear on the LED readout and will flash intermittently.
3. Turn on the Bluetooth feature on your device and ensure that it is discoverable. Look
for and select “Rock Party 8” from the list of available devices.
4. Upon successful pairing, the word bLUE will stop flashing.
5. Use the PLAY/PAUSE button to pause and resume playback.
6. Use the PREVIOUS/NEXT buttons for track selection.
7. Use the master VOLUME knob to set the volume level.
AUX
The 3.5mm AUX jack allows for input from smartphones, MP3 players, CD players, or any
other external signal source with a 3.5mm jack or RCA outputs. Please note you will need
either a 3.5mm-to-3.5mm cable or an RCA-to-3.5mm cable (not included).
1. Make sure the speaker is OFF.
2. Set the master VOLUME to the lowest setting.
3. Connect signal source to the 3.5mm AUX input.