INSTALL INSTRUCTIONS
Escape Series
Periscape
™
4 • Periscape
™
6 • Subscape
™
8 • Subscape
™
10 • Subscape
™
12
Ultra-Fidelity Outdoor Speakers
Contact: MSE Audio, 855.663.5600 / 913.663.5600 / [email protected]
We recommend a minimum system consisting of four (4) units of
the Periscape speaker and one (1) Subscape subwoofer. It is
acceptable to have up to eight (8) units of the Periscape speaker
with a single subwoofer, but it is recommended to add a second
subwoofer for installations of more than eight (8) Periscape units.
The final number of speakers and subwoofers will depend on the
coverage needed for the intended space. Sufficient amplifier
power will need to be provided to accommodate the final number
of speakers in the installation. Contact your Rockustics dealer or
email [email protected] for assistance if needed.
Included are some typical installation layouts for reference.
The Periscape and Subscape speakers all come equipped with
high voltage (70V) transformers and may also be run in an 8 ohm
direct mode. The included tap switch provides different tap
settings and a transformer bypass option which allows for
maximum flexibility in installing and tuning the system. See the
figures below for typical 70 Volt and 8 Ohm wiring configurations.
Periscape Speaker Installation
• Rockustics recommends using either 14 gauge or 16 gauge
direct-burial rated cable.
• It is best to lay out the cable to each of the intended speaker
locations before installing the speakers. Once the speakers are
installed and the system has been tested, bury the speaker cable
3-5” deep in the ground.
8 Ohm Wiring Diagram
4 Ohm Amplifier
(Speakers Wired in Parallel)
Phase Tech P350
350 W Subwoofer Amplifier
Audio
Source
Expandable
70V Wiring Diagram
SoundTube MA3501t
70V Amplifier
Note:
Subwoofer can be
connected anywhere in
the daisy chain
HOUSE
PATIO
SUB
PATIO
POOL
HOUSE
SUB
SUB
