Rockustics Music Garden Owner'S Manual Download Page 3

2. Measure Wiring

Measure, cut, and lay your wire 
runs between your speakers 
and the amplifier for a total of 6 
wire runs (see diagram above). 
Add an extra 6” of length to 
each wire run.

HOUSE

PATIO

SUB

Amp

L1

L2

R2

R1

AMP

1. Layout Design

Determine the layout of your 
system. Place each speaker 
in the general location it will 
be installed. Also place your 
amplifier where it will be 
installed.

3. Dig Your Holes

Dig a hole for each satellite (x4) 
where you’ve determined they 
will be installed.

3A. Keep Digging!

The port tube should extend 
3-5” above the final landscaping 
grade. Be sure to accommodate 
any bark mulch or ground cover 
when determining the burial 
depth of the subwoofer.

4. Wiring Diagram

Start wiring (See Diagram above). You have 2 left channel satellite 
speakers, 2 right channel satellite speakers, a subwoofer, and an 
amplifier that are all wired together.

HOUSE

PATIO

SUB

AMP

OS-440 Amplifier

L1

L2

R2

R1

Subwoofer

Left Channel Right Channel

+  -  -  +

+  -  -  +

L1

Sub

L2

5A. DO NOT!

DO NOT RUN THROUGH 
THE BOTTOM OF THE 
SPIKE! RUN THROUGH THE 
ACCESS HOLE!

6. Wiring (L2 to Sub)

-Using the included waterproof 
wire nuts, connect the RED wire 
coming from L2 to the BLUE
wire coming out of the Sub.
-Connect the BLACK wire 
coming from L2 to the BLACK 
wire coming out of the sub

.

8. Wiring (L1 to Amp)

Run your left channel wiring 
from the amp to the L1 speaker 
through the wire access hole in 
the ground spike.

Sub

Amp

L1

L2

~6”

~8”

~12”

~20”

L1

L2

5. Wiring (L1 to L2)

For convenience, temporarily 
twist the two red wire leads 
and the two black wire leads 
together.

8A. OS-440 Amp Wiring

Rockustics recommends that 
you use Phase Technology’s 
OS-440 amplifier to power your 
new speaker system. Refer to 
the OS-440 manual for amp 
configuration and follow the 
wiring diagram above.

Left Channel            Right Channel

+   -    -   +

+   -    -   +

R1

Sub

R2

7. Wiring (R2 to Sub)

-Using the included waterproof 
wire nuts, connect the RED wire 
coming from R2 to the YELLOW 
wire coming out of the Sub.
-Connect the BLACK wire 
coming from R2 to the BROWN 
wire coming out of the sub

.

Reviews: