9
8
CONSTRUCTION AND TECHNICAL DATA
SERVICE
BATTERY
Always fully charge the battery before using it for the first time. The battery will warm up while
charging, this is normal. Remember the battery is an consumable part that is subject to natural wear.
When it is worn out, replace it with a new one. The battery has overload safety systems that protect
the device and will work if the device is overloaded and overheated. You should then wait about 30
minutes for the device and the battery to cool down. However, in some cases, the battery may be
permanently damaged. In such cases, the battery should be replaced with a new one. In the event
of damage related to overload, the battery is not subject to complaint. Charge the battery regularly,
at least once every 3 months. Even if the device is not in use. Discontinue use of the device if the
battery is discharged and the device stops while operating. Do not turn it on again, just replace or
recharge the battery immediately. An attempt to operate with a discharged battery may lead to
permanent damage to the battery.
1. Handle
2. Handle lock
3. Main switch
4. Gear and rotational speed switch
5. Battery
6. Mounting bracket M14
7. Agitator shaft
8. Mixing head
9. Assembly wrenches for the shaft
and the mixing head
Voltage
DC 18 V
Diameter of the mixing head
120 mm
Rotation speed
0-450-720 rpm
Shaft mounting size
M14
Weight
4,2 kg
Additional equipment (only in OK-03.4315)
Battery
4 Ah
Charger
21 V / 5 Ah
Charging time
2 h
2
3
5
1
4
6
7
8
9
Summary of Contents for OK-03.4314
Page 25: ...25 0 450 720 120 M14 AQ ONE 20 AQ ONE 30 RU...
Page 27: ...27 1 2 1 2 3 4 5 1 22 2 22 3 E E D1 D2...
Page 31: ...31 NOTATKI NOTES...
Page 32: ...32...
