System test
Select the car electrical system test:
SYSTEM TEST - ENTER
• Turn off all consumers and start the engine
• The tester will indicate the starting voltage
• Start charging test
• Turn off all receivers
• Perform the test without load
• Switch on all receivers and perform a load test
• Test complete
• Print a report
Possible test results:
• CRANKING VOLTS NORMAL - correct starting voltage
• CRANKING VOLTS LOW - Inrush voltage too low
• CRANKING VOLTS NOT DETECTED - Inrush voltage has not been detected
• ALT.IDLE VOLT NORMAL - good no-load voltage
• ALT.IDLE VOLT LOW - charging voltage without load too low
• ALT.IDLE VOLT HIGH - charging voltages without load for dredges
• ALT LOAD VOLT NORMAL - correct charging voltage
• ALT LOAD VOLT LOW - charging voltage too low
• ALT LOAD VOLT HIGH - too high charging voltage
3
2
ALT. IDLE VOLTS
X.XX V NORMAL
[ENTER]
SYSTEM TEST
XX.XX V
[ENTER]
TUEN OFF LOADS
START ENGINE
[ENTER]
CRANKING VOLTS
XX.XX V NORMAL
[ENTER]
PRESS ENTER FOR
CHARGING TEST
[ENTER]
MAKE SURE ALL
LOADS ARE OFF
[ENTER]
TURN ON LOADS
AND PRESS ENTER
[ENTER]
ALT. LOAD VOLTS
X.XX V NORMAL
[ENTER]
TEST OVER. TURN
OFF LOADS&ENGINE
[ENTER]
PRINT RESULT
NO
[ENTER]
PRINT RESULT
YES
[ENTER]
Press the "Enter" button to confirm and return to the main interface
1
