11
Turning on the Dust Right 1250 CFM Wall Mount Dust Collector
is a two-step process that can be accomplished at the machine or
with the Remote Control.
The radio-frequency Remote Control operates on one 9-Volt
battery (not included) and has an effective range of up to
about 25 feet.
1. Lift the paddle of the Main Power Switch.
2. Press the Start/Stop Button on the control module OR
the ON button on the Remote Control. (Make sure the
9-Volt Battery is installed.)
Clearing and Resetting the Remote
If the Remote Control (9) fails to function, try installing a new
battery. If it still will not work, you must clear and reset the
remote.
1. Press the Remote Reset button on the unit’s power panel
for three seconds, until the receiver “beeps” three times.
2. Press the Remote Reset button on the unit’s power panel
for one second, until the receiver “beeps” once.
3. Press the ON button on the handheld Remote Control (9)
until the light on the receiver “beeps” twice.
4. Press the Remote Reset button on the unit’s power panel
for three seconds, until the receiver “beeps” three times.
The Remote Control is now reset.
Overload Reset
The Dust Right 1250 CFM Wall Mount Dust Collector
incorporates overload protection to help prevent damage to the
motor. If the motor is drawing excessive current during periods of
extended operation and begins to overheat, a relay in the control
panel will break the circuit and shut off the dust collector.
If the overload protection is tripped:
1. Flip the Main Power Switch to the OFF position and
unplug the machine.
2. Allow the motor to cool.
3. Press the Circuit Breaker Reset button.
4. Plug in the cord and turn on the unit.
Maintenance
1. Periodically inspect dust and filter bags for any cuts, rips
or tears. Do
NOT operate the dust collector with a damaged
bag or hose.
2. Empty bag regularly. Do NOT fill the bag more than half-full.
3. All bearings are shielded and permanently lubricated. No
other lubrication of this machine is necessary.
4. When the machine is not being used, unplug the power
cord from the outlet and store the cord away from any
potential sources of damage, including high-traffic areas,
sharp objects, sources of heat, harsh chemicals and moisture.
Changes or modifications to this unit not
expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Check Rockler.com for updates. If you have further questions, please
contact our Technical Support Department at 1-800-260-9663
IDENTIFICATION OF ASSEMBLED PRODUCT
1250 CFM WALL-MOUNT DUST COLLECTOR INSTRUCTIONS
(54352/UB105Z) WITH REMOTE CONTROL (IC-315Z)
IDENTIFICATION OF MODULAR COMPONENTS USED
REMOTE CONTROL FCC ID ANZ-IC-315Z
APPLICABLE COMPLIANCE STATEMENTS
NOTE:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment
and receiver.
— Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV
technician for help
RESPONSIBLE PARTY / MANUFACTURER
ROCKLER COMPANIES
ADDRESS 4365 WILLOW DRIVE, MEDINA, MN 55340
TELEPHONE 1-800-279-4441
WWW.ROCKLER.COM
Frequency Range: 315 MHz
Modulation Type: Amplitude-shift keying (ASK)
Bandwidth: 189.58 KHz
Number of Channels: 1 channel
Power Operation: DC 9V Battery
