4
Check Rockler.com for updates. If you have further questions, please
contact our Technical Support Department at 1-800-260-9663
6.
With the rear corner section assembled, lay out the two
22.5° Legs with the two Front Stretchers in between, making
sure that the Stretchers are on the inside of the Legs and
oriented so the mitered top flanges are facing up.
7.
Connect the Front Stretchers to the 22.5° Legs with a
5/16"-18 Carriage Bolt, Washer and 5/16"-18 Nut in each
square hole, starting with the top holes. Before fully
tightening the nuts, use a square to make sure that
the Stretchers and Legs are joined at 90°.
8.
Attach the front section from Step 7 to the rear corner
section with two 16" Stretchers on each side, making sure
that the Stretchers are oriented so the mitered top flanges
are facing up. Connect the 16" Stretchers to the 22.5° Legs
of the front section and the 90° Legs (1) of the rear corner
sections with a 5/16"-18 Carriage Bolt, Washer and 5/16"-18
Nut in each square hole. Again, before fully tightening the
nuts, use a square to make sure that the Stretchers and
Legs are joined at 90°.
9.
Mount the top of your choice and, if desired, a shelf,
using the mounting holes in the mitered flanges of the
Stretchers. (Mounting hardware for top and
shelf not included.)
10.
If necessary, adjust the Leveling Feet so the stand sits
solidly on the floor.
11.
Apply the Rockler sticker to one of the Front Stretchers.
We recommend centering it on the lower Front Stretcher.
Distributed by Rockler Companies, Inc.
4365 Willow Dr. Medina, MN 55340
66877 66915
Rev 0921
1-800-279-4441
www.rockler.com
Front Sub-Assembly
Washer
5/16"-18 Nut
5/16"-18 Carriage Bolt
Front Stretcher
16" or 20" Stretcher
22.5° Leg
