1
Tools Needed
The following is a list of some of the tools necessary for the installation of
your speakers.
• Power Drill with assorted bits
• #2 Phillips Screwdriver
• Tape Measure
• Voltmeter
General
1.
For safety,
disconnect the negative lead from the battery prior to beginning the
installation.
2. Never run wires underneath the vehicle.
Running the wires inside the vehicle pro-
vides the best protection.
3. Avoid running wires over or through
sharp edges. Use rubber or plastic grom-
mets to protect any wires routed through
metal.
4. Mount the speakers away from electrical
sources (other than the amplifier) i.e.,
power cables, electronic fuel pumps,
vehicle computers, and other potential
noise sources.
5. Mount the speakers away from areas of
extreme heat or moisture.
Speakers
1. Make sure there is an area large enough for the speaker to mount.
Warning!
Failure to do this can cause damage to the speaker if the speaker frame is
bent during installation.
2. Check to see that the location is deep enough for the speaker(s) and the loca-
tion does not interfere with the normal operation of the vehicle.
3. When mounting the speaker(s) in the door of a vehicle, make sure the speak-
er(s) do not interfere with either the door or window operation.
4. When mounting the speaker(s) on the rear deck of the vehicle, check the
operation of the rear hatch or trunk lid. Make sure the torsion bars and other
moving parts are not obstructed by the speaker(s) installation.
• Please refer to the
Specifications section
of this manual for proper mounting
diameter and depth of the speaker(s).
I
NSTALLATION
C
ONSIDERATIONS
