5
I
NSTALLATION
This section focuses on some of the vehicle considerations for installing your new Rockford Fosgate
Hybrid Capacitor. Pre-planning your system layout and best wiring routes will save installation time.
When deciding on the layout of your new system, be sure that each component will be easily accessible
for making adjustments.
CAUTION
: If you feel unsure about installing this system yourself, have it installed by
a qualified Rockford Fosgate technician.
CAUTION
: Before installation, disconnect the battery negative (-) and positive (+)
terminals to prevent damage to the unit, fire and/or possible injury.
Before beginning any installation, follow these simple rules:
1.
Be sure to carefully read and understand the instructions before attempting to install the unit.
2.
For safety, disconnect the negative lead from the battery prior to beginning the installation.
3.
For easier assembly, we suggest you run all wires prior to mounting your unit in place.
4.
Route all of the high current wires close together and away from any RCA cables.
5.
Use high quality connectors for a reliable installation and to minimize signal or power loss.
6.
Think before you drill! Be careful not to cut or drill into gas tanks, fuel lines, brake or hydraulic lines,
vacuum lines or electrical wiring when working on any vehicle.
7.
Never run wires underneath the vehicle. Running the wires inside the vehicle provides the best
protection.
8.
Avoid running wires over or through sharp edges. Use rubber or plastic grommets to protect any
wires routed through metal, especially the firewall.
9.
ALWAYS protect the battery and electrical system from damage with proper fusing. Install the
appropriate fuse holder and fuse on the +12V power wire within 18” (45.7 cm) of the battery
terminal.
10. When grounding to the chassis of the vehicle, scrape all paint from the metal to ensure a good, clean
ground connection. Grounding connections should be as short as possible and always be connected to
metal that is welded to the main body, or chassis, of the vehicle.
MOUNTING LOCATIONS
Select a dry location that will provide good ventilation around the Rockford Hybrid Capacitor.We
recommend that you mount the capacitor on the floor of the trunk or in a location where
it will be protected from water damage.
• Mount in a location free from grease, water, flames, sparks or heat. Preferably in the trunk of the
vehicle.
• The capacitor should be mounted with the supplied screws as close to the amplifier as possible
keeping the wire runs short. It is recommended that runs be kept less than 24 inches, as this will
help to reduce voltage loss in the cables.
• Mark the location where the capacitor is to be mounted. After wiring the system, mount the
capacitor into place.
WIRING THE SYSTEM
CAUTION
: If you do not feel comfortable with wiring your new unit, please see your
local Authorized Rockford Fosgate Dealer for installation.
CAUTION
: Before installation, disconnect the battery negative (-) and positive (+)
terminals to prevent damage to the unit, fire and/or possible injury.
CAUTION
: Avoid running power wires near the low level input cables, antenna, power
leads, sensitive equipment or harnesses.The power wires carry substantial
current and could induce noise into the audio system.
CAUTION
: Improper wiring connections can seriously damage the capacitor and/or
your vehicle. Be sure to carefully follow the connection instructions in this
manual. Improper wiring will void warranty.