Rockford Fosgate RAV DVD2, Installation And Operation Manual

Page: 28 / 92

28
S
YMPTOM
D
IAGNOSIS
R
EMEDY
Source Unit does
not turn on Voltage applied to Red and Yellow wires is not
between 10.8 and 16 volts or there is no
voltage present Check battery, connections and fuses and repair or replace as
necessary. If voltage is above +16 volts, have the electrical system
inspected by an authorized car service center.
Unit is not properly grounded Check wiring and repair as necessary
Speakers pop when
turning Source
Unit On/Off Auto antenna and remote B+ are not
configured properly Check wiring and repair as necessary. Refer to “Wiring the
System” section of this manual for further information
Bad component in the signal chain Check connections and bypass all components between the source
unit and the amplifier. Connect one component at a time to
determine the culprit. Connect this component to the Blue wire
and check for pops. Repair or replace component as necessary
Tuner fails to tune
any stations Antenna is disconnected Check connections and repair as necessary
Center or Subwoofer
speaker outputs do
not function Speakers have not been setup in menu
selection Configure speakers being used. See INSTALLATION for more
information
General
NOTE
: If the error still continues after doing one of the easy remedies, before taking the unit to a service
dealer, try resetting the system by pressing the reset button.
Tuner has poor
reception Antenna is disconnected or not properly
grounded to vehicle Check connections and installation of antenna and repair or
replace as necessary
Antenna cable is intermittent or damaged Disconnect antenna and test with known working antenna. If tuner
works, check installation and repair antenna as necessary
Antenna is wrong type Consult your local Authorized Rockford Fosgate Dealer for proper
antenna selection
Video screen does
not come on, no
picture Poor connections. Brake wire connected
improperly Check connections and repair as necessary
Disc will not load
into Source Unit
(also see error
codes) Voltage applied to Red and Yellow wires is not
between 10.8 and 16 volts or there is no
voltage present Check battery, connections and fuses, and repair or replace as
necessary. If voltage is above +16 volts, have the electrical system
inspected by an authorized car service center
T
ROUBLESHOOTING
ERROR 6, 7 or 9
(Bad Disc or Disc
Error) Excessive dirt or dust on disc Clean disc to remove dirt or dust as necessary
Disc is warped cracked or severely damaged Put in a different disc!
Excessive scratches on disk Put in a different disc!
Laser pickup is defective
Have service center repair laser pickup
Disc will not eject
(also see error
codes) Voltage applied to Yellow wire is not between
10.8 and 16 volts or there is no voltage
present Check battery, connections and fuses, and repair or replace as
necessary. If voltage is above +16 volts, have the electrical system
inspected by an authorized car service center