10
S
PECIFICATIONS
MODEL- PRIME
R600-5
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4
Load Per Channel
50 Watts x 4 + 200 Watts x 1
2
Load Per Channel
75 Watts x 4 + 300 Watts x 1
4
Load Bridged
150 Watts x 2 + n/a
Dimensions:
Height
2.40" (6.10cm)
Width
7.67" (19.49cm)
Length
17.09" (43.40cm)
Amplifier Fuse Rating (Amp)
(2) 40A ATC
External Battery Fuse Rating (Not Supplied)
80A
“A” Weighted Signal to Noise Ratio
Referenced to 1 Watt into 4 ohms (CEA-2006)
>70 dB
“A” Weighted Signal to Noise Ratio
Referenced to rated output into 4 ohms
>90 dB
Amplifier Topology (Ch. 1/2/3/4)
Class A/B
Amplifier Topology (Sub)
Class D
Crossover Slope
12dB/octave Butterworth
Crossover Frequency (Ch. 1/2/3/4)
High-Pass: 80Hz
Low-Pass: variable from 50Hz to 250Hz
Crossover Frequency (Sub)
Low-Pass: 40Hz to 130Hz
Frequency Response
20Hz to 20KHz ±1dB
Signal Voltage Adjustment Range
Variable from 150mV to 8V (RCA Input)
Protection
Short circuit protection shut downs the amplifier in
case of very low impedance or shorted speaker wires.
Punch Bass (Ch. 1/2/3/4)
0dB/+6dB/+12dB @ 45Hz
Punch Bass (Sub)
Variable from 0dB to +12dB @ 45Hz
Phase (Sub)
1°/180°
Input Impedance
20K ohms
Operating Voltage
9 to 16 Volts DC
Balanced Inputs
No
CMRR (Common Mode Rejection Ratio)
>40dB @ 1KHz
Damping Factor
>200
THD+N (Total Harmonic Dist Noise)
< 1.0% @ 4 ohm
These specifications are Amplifier Power Standard CEA-2006 Compliant
Specifications subject to change without notice
