CPU0204
5
ADJUSTING THE SPRAY PATTERNS
To adjust the spray patterns proceed as follows:
1. Hold the shaft of the lance in one hand.
2. Turn the nozzle clockwise to obtain FAN spray pattern.
3. Turn the nozzle anticlockwise to obtain STREAM spray pattern.
4. Slide the nozzle out to LOW-PRESSURE position to obtain
DETERGENT dispense.
TOTAL STOP SYSTEM
The pressure washer is fitted with a total stop system to protect the motor when in use.
When the trigger is released the motor will stop.
When the trigger is squeezed the motor will start up again.
USING DETERGENTS
The pressure washer will dispense detergent only at low pressure.
Use the adjustable spray nozzle to apply detergents and to rinse clean.
Biodegradable detergents are specifically formulated to protect the environment and your pressure washer. These
Detergents will not clog the filter and will protect the internal parts of the pressure washer for a longer life.
Step 3
Insert the Nozzle into the connector, push and turn the nozzle clockwise onto the connector until hand tight to lock it in
place.
Step4
Attach the connector to the spray gun handle
Step5
To apply the detergent cleanser to your working area, turn the pressure washer switch to the ON position. Pull the
trigger to operate the unit. The pressure washer will mix the detergent with water. Do not allow the detergent to dry on
the object that you are cleaning.
WARNING
: NEVER USE PRODUCTS WITH BLEACH OR CHLORINE OR ANY OTHER CORROSIVE MATERIALS,
INCLUDING LIQUIDS CONTAINING SOLVENTS (I.E. GAS, OILS ETC), TRI-SODIUM PHOSPHATE PRODUCTS,
AMMONIA, OR ACID-BASED CLEANERS.
THESE CHEMICALS WILL HARM THE UNIT AND CAUSE DAMAGE TO THE SURFACE BEING CLEANED.
ALWAYS READ THE LABEL.
Step 6
Step 1
Take out the bottle from the holder and
open the cap of bottle.
Step 2
Fill the detergent reservoir with any
approved liquid detergent. Close the cover.
