17
RF-WHTIB-A
Specifications
Wireless sender
No communication between
the sender and receiver
• Make sure that the power cords are connected
correctly.
• After the power switches have been turned on on both
the wireless sender and wireless receiver, the front
panel LEDs should light. If they are solidly on, a
communication link has been successfully established
between the units. If they are flashing on one or both
units, press and hold the
CONNECT
button on either
the wireless sender or wireless receiver for two
seconds. (Both the wireless sender's and the wireless
receiver's
CONNECT
buttons are on the bottom.) This
will put the unit into the “connection mode” for about
30 seconds. During this period the
CONNECT
button
on the other unit must also be pressed for two seconds
so that it will also enter “connection mode.” The system
proceeds with the connection process between the
wireless sender and wireless receiver. While in
“connection mode,” the LED indicators blink at a faster
rate. When an active link is established between the
wireless sender and wireless receiver, the LED
indicators will be solid on and will not blink.
Note:
Try pressing the
CONNECT
buttons again if the LED indicators keep
blinking after 30 seconds.
Audio Input: Stereo,
speaker-level
• Maximum audio input signal: 11 V
RMS into 120 ohms
Audio Output: Wireless
• Stereo, 16-bit, 48 KHz uncompressed
Supply voltage
• 5V
Transmission Delay
• 15-20 ms
Problem
Solution
RF-WHTIB_16-0683_MAN_V4_ENG.fm Page 17 Tuesday, September 6, 2016 8:50 AM
