14
Need help? Call 1-800-620-2790 (U.S. and Canada)
STEP 6
-
Option 2: Installing on a solid concrete or concrete
block wall
CAUTION
: To prevent property damage or personal injury, never drill into mortar
between blocks. Mount the wall plate directly onto the concrete surface.
Note
: Minimum solid concrete thickness: 8 in (203 mm). Minimum concrete block
size: 8 x 8 x 16 in. (203 x 203 x 406 mm).
1
Align the center of the wall plate template (
11
) at the height you determined in
the previous step and make sure that it is level. Tape the wall plate template to
the wall, then use a pencil to mark the lag bolt hole locations (2). Remove the
wall plate template.
2
Drill pilot holes to a depth of 3 in. (75 mm) using a 3/8 in. (10 mm) diameter
masonry drill bit.
3
Insert the concrete wall anchors (refer to Concrete Installation Kit CMK1 (not
included) on page 4) into the pilot holes and use a hammer to make sure that the
anchors are flush with the concrete surface.
4
Align the wall plate (
12
) with the anchors, insert the lag bolts (
C1
) through the
holes in the wall plate assembly, then tighten the lag bolts only until they are
firm against the wall plate.
CAUTION
: Avoid potential injuries or property damage!
DO NOT over-tighten the lag bolts (
C1
).
!
cured, simply pick-up
e wall plate and lock
tab
ations!
You’re done.
!
If you have questions
stome
r
G
TEP 3
GET STAR
TED
WITH STEP
1
e
line them up
k of your
TV.
late to
rough.
ck-up
all plate
and lock tab
atulations!
You’re
done.
!
If you have question
s
omer
LY GOING
TEP 3
GET ST
ARTED
WITH STEP
1
brac
TV.
t
3 in.
(75 mm)
3/8 in.
(10 mm)
RF-HTVMTAB_16-0417_MAN_V2_ENG.fm Page 14 Friday, June 3, 2016 2:41 PM
