rock space RSD0613, User Manual, Page: 10 / 16

FAQ
A1: Run the RS WiFi App, tap Settings in the lower-right corner, tap Wireless
Settings , change your SSID and password, and tap Save .
Then, you need to reconnect your mobile devices using the new SSID and
password.
A2: Tap the node on the RS WiFi App, tap “ … ” in the upper-right corner, and
choose “ Delete ”.
Note: Removing operation restores the node to factory settings.
A
4: With the nodes powered on, hold the Reset button of your primary node down
using a paper clip for about 6 seconds, release when the LED indicator blinks
fast. Your network is reset successfully when the LED indicator lights solid on
then blinks again. And all nodes are restored to factory settings
A3: Yes. Run the RS WiFi App, tap Settings in the lower-right corner, tap Add
Nova , and follow the on-screen instructions to add.
Q1: How can I change my SSID and password?
Q2: How can I remove node from my WiFi network?
Q4: How to restore my network to factory settings?
Q3: Can I add another new set of node to expand my network coverage?
A5:
If your 2.4 GHz WiFi-enabled device supports the WPS function, perform the
steps below:
Step 1 Run RS WiFi App, tap Settings , WPS , and the WPS button
corresponding to the node near your device.
Step 2 Within 2 minutes, enable the WPS function on your device.
If your 2.4 GHz WiFi-enabled device does NOT support WPS function, perform
the steps below:
Step 1 Connect your smart phone used for setup to the WiFi network.
Step 2 Run RS WiFi App, tap Settings , Smart Assistant , and Enable . Your
smart phone connects to the 2.4 GHz WiFi network.
Step 3 Use the smart phone to set up your 2.4 GHz WiFi-enabled device
guided by its App.
Q5: My 2.4 GHz WiFi-enabled devices, such as a home security camera, cannot
connect to my nova WiFi network. What should I do?