RocHobby FMMROC009RTR, Instruction Manual

Page: 11 / 76

instructions
After setting up, follow the instructions below to operate the system.
1. Automatic code matching (the transmitter and receiver have been successfully coded before
leaving the factory.)
1. When the transmitter power is on and the code matching mode is on, the light keeps flashing;
2. The power supply of the receiving board is turned on, and the front lights keep flashing to enter the code
matching mode;
3. When the code matching is successful, all the transmitter lights are on and all the lights on the car are off;
If you need to replace another transmitter or receiver, please follow the following steps to code:
Note: when code matching, please operate the transmitter to enter the code matching state first, and then
operate the receiver to enter the code matching state.
2、 POWER OFF
instructions
2-3S 锂电或 5-9 芯镍氢电
2S 锂电或 5-6 芯镍氢电 540 或 550 电机 ≥8T 或 RPM <45000@7.2V
1、
Transmitter specification
Adaptive model
RF
Wireless protocol
Transmitting power
Product Model
Car
2.4GHz
ANT
<20dBm
HT-TX02
11
EN
1.Disconnect the receiver power.
2.Toggle the transmitter's power switch to the off position.
Follow the steps below to turn off the system:
Danger
Make sure to disconnect the receiver power before turning off the transmitter. Failure
to do so may lead to damage or serious injury.