Roche OMNI C, Instructions For Use Manual

Page: 42 / 152

1 Introduction
1-34
Instructions for Use, Roche OMNI C, Rev. 4.0, December 2002
If available (option):
12. Shutting down the AutoQC module
• Open the cover and remove the AutoQC ampoule block.
• The carriage in the AutoQC module moves to the service position.
•
Close all covers.
TIP: After successfully shutting down the instrument, it will be in the "System stop" mode
(shut down). Only a renewed installation procedure can alter this status.
• Switch the instrument OFF.
• Shut down is complete.
13. Uninstall the AutoQC module
• Pull the cable of the AutoQC module from the jack on the reverse side of the instrument
(see Fig. 41).
Fig. 41
• Remove both tube ends in the bottle compartment from the docking part.
Fig. 42
• Unlock the AutoQC module by pulling the unlocking knob (see Fig. 41) on the reverse
side of the instrument and remove the AutoQC module from the tracks on the
Roche OMNI C.
unlocking knob