Roche OMNI C, Instructions For Use Manual

Page: 30 / 152

1 Introduction
1-22
Instructions for Use, Roche OMNI C, Rev. 4.0, December 2002
10. Insert FMS tubes
• Slide the feed tube of the C1 solution under the tube clip (valve V1).
• Slide the feed tube of the C2 solution under the tube clip (valve V2) (see Fig. 18).
Both of these valves are located on the back wall of the bottle compartment.
Fig. 18
11. AutoQC module (option)
• Open the cover of the AutoQC module.
•
Insert the AutoQC ampoule block.
• Close the cover of the AutoQC module.
• Perform the mat assignments and program the AutoQC times.
Please see chapter 5,
"Quality Control" !
12. Attach pump tube
•
Open the instrument cover.
• Open the peristaltic pump's clear plastic cover (tension lever). Push the linear bracket
(white plastic part) upwards (Fig. 19).
• Place the tube around the rolling wheel.
•
Close the clear plastic cover (tension lever). The tubing holder is then pressed into the
sealer.
Fig. 19
feed tube: C2 solution
feed tube: C1 solution
V2
V1
tension lever
linear clamp
pump head
pump open pump closed