Robust 44.720.27, Original Operating Instructions

Page: 19 / 48

19
GB
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
5. Technical data
Mains voltage: 230 V ~ 50 Hz
Power input: 2200 W
Idling speed: 8000 rpm
Max. wheel diameter: 180 mm
Mounting spindle thread: M14
Protection class: II /
쏾
Weight: 5,3 kg
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Additional information for electric power tools
Keep the noise emissions and vibrations to a
minimum.
n
Only use appliances which are in perfect working
order.
n
Service and clean the appliance regularly.
n
Adapt your working style to suit the appliance.
n
Do not overload the appliance.
n
Have the appliance serviced whenever
necessary.
n
Switch the appliance off when it is not in use.
n
Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment’s
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
6. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
6.1 Fitting the additional handle (Fig. 2)
n
The angle grinder must not be used without the
additional handle (3).
n
The additional handle can be secured in any of
three positions (A, B, C).
6.2 Adjusting and replacing the guard (Fig. 3)
Pull out the power plug!
n
Switch off the equipment. Pull out the power plug.
n
Adjust the guard (7) to protect your hands so that
the material being ground is directed away from
your body.
n
The position of the guard (7) can be adjusted to
any specific working conditions. Undo the clamp
handle (a) and turn the cover (7) into the required
position.
n
Ensure that the guard (7) correctly covers the
gear wheel casing.
n
Secure the clamp handle (a) again.
n
Ensure that the guard (7) is secure.
n
To remove the guard, open the clamp handle (a)
and turn the guard far enough to be able to
remove it.
n
To fit the guard, proceed in reverse order to
removing the guard.
Take care that the safety device is secure.
Never use the angle grinder without the
guard.
6.3 TEST RUN FOR NEW GRINDING WHEELS
Allow the right-angle grinder to run in idle for at least
1 minute with the grinding or cutting wheel fitted in
place. Vibrating wheels are to be replaced
immediately.
Tool side Suitable for
Left (position A) Right-handed users
Right (position B) Left-handed users
Top (position C) Use of cutting wheels
Anleitung_RB_AG_2200_SPK7__ 21.11.12 13:39 Seite 19