Transport and positioning
24
2
K18 Hybrigas Boiler
Gas consumption
methane G20 (nominal)
m³/h
1,90
G30 (nominal)
kg/h
1,42
G31 (nominal)
kg/h
1,40
Percentage CO
2
in fumes
Nominal thermal capacity
G20
%
9,44
G30
%
11,10
G31
%
10,20
Minimal thermal capacity
G20
%
9,04
G30
%
10,50
G31
%
10,05
Flue temperature
Nominal thermal capacity
G20
°C
73,7
FUMES FLOW RATE
Nominal thermal capacity
G20
kg/h
28
Minimal thermal capacity
G20
kg/h
5
CO emission
ppm
41,0
2
TRANSPORT AND POSITIONING
2.1
WARNINGS
Damage from transport or installation
The manufacturer shall not be liable for any damage dur-
ing appliance transport and installation.
On-site inspection
▶
Upon arrival at the site, ensure there is no transport damage
on packing, metal panels or finned coil.
▶
After removing the packing materials, ensure the appliance
is intact and complete.
Packing
▶
Only remove the packing after placing the appliance on site.
▶
Do not leave parts of the packing within the reach of chil-
dren (plastic, polystyrene, nails...) since they are potentially
dangerous.
Weight
▶
The lifting equipment must be suitable for the load.
▶
Do not stand under suspended loads.
2.2
HANDLING
Handling and lifting
▶
Always handle the appliance in its packing, as delivered by
the factory.
▶
Use slings to lift the appliance.
▶
Use to lifting beams to avoid damaging the outer pan-
els, finned coil and defrosting water discharge (Figure
2.1
▶
It is possible remove defrosting water and flue gas conden-
sate discharge conveyor during handling to avoid damages
(reference F Figure 1.3
p. 10) using screws; reassemble the
discahrge conveyor when handling is ended.
▶
Comply with safety regulations at the installation site.
Figure 2.1
Instruction for lifting
In the event of handling with forklift or pallet truck,
comply with the handling instructions shown on the
packing.
Pay attention to the unit centre of gravity position
(Figure 2.2
p. 25).