FOR YOUR SAFETY READ BEFORE OPERATING
A. This appliance does not have a pilot. It is
equipped with an ignition device which
automatically lights the burner. Do not try to light
the burner by hand.
B. BEFORE OPERATING smell all around the
appliance area for gas. Be sure to smell next to
the floor because some gas is heavier than air
and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
- Do not try to light any appliance
- Do not touch any electric switch
- Do not use any phone in your building
- Immediately call your gas supplier from a
neighbour’s phone. Follow the gas
supplier’s instructions.
- If you cannot reach your gas supplier, call the
fire department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will not
push in or turn by hand, don’t try to repair it, call a
qualified service technician. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas control
which has been under water.
OPERATING INSTRUCTIONS
1. STOP! Read the safety information above on this
label.
2. Set the control switch to “OFF” position.
3. Turn off all electric power to appliance.
4. This appliance is equipped with an ignition device
with automatically lights the burner. Do not try to
light the burner by hand.
5. Remove control access panel.
6. Push in gas control knob slightly and turn
clockwise to “OFF”.
NOTE: Knob cannot be turned to “OFF” unless
knob is pushed in slightly. Do not force.
7. Wait (5) minutes to clear out any gas. If you then
smell gas, STOP! Follow “B” in the safety
information above on this label. If you don’t smell
gas, go to the next step.
8. Turn gas control knob counterclockwise to
“ON”.
9. Replace control access panel.
10. Turn on all electric power to the appliance.
11. Set thermostat to desired setting.
12. If the application will not operate, follow the
instructions “To Turn Off Gas Of Appliance”
TO TURN OFF GAS TO APPLIANCE
13. Set the control switch to “OFF” position.
14. Turn off all electric power to the appliance if
service is to be performed.
15. Remove control access panel.
16. Push in gas control knob slightly and turn
clockwise to “OFF”. Do not force.
17. Replace control access panel.
WARNING:
If you do not follow these instructions exactly, a fire
or explosion may result causing property damage, personal injury
or loss of life.
INLET
OUTLET
GAS CONTROL KNOB
SHOWN IN “ON” POSITION
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliances
