RoboVent PFX Series, Owner'S Manual

Page: 12 / 52

12 ROBOVENT • PFX SERIES OWNER’S MANUAL
Receiving
RoboVent equipment is typically shipped on skids or direct loaded. The number of
skids will vary, depending the type, size and accessories ordered. The skids or direct
loaded equipment are too heavy to lift by hand. The items will need to be unloaded by
an industrial forklift, crane, or overhead crane.
Inspection
A visual inspection of your equipment should be performed before it is removed from
the truck. Dents, scratches, and other damages should be noted on the shipping
documents, and also photographed. The structural integrity of the housing can
be adversely affected by large dents. RoboVent should be immediately notified
of any structural damage to your equipment. It is the purchaser’s responsibility to
file shortage reports and damage claims with the carrier and with your RoboVent
Representative. The carrier is responsible for any damage to the equipment while it is
in transit unless specific arrangements are made otherwise.
Compare the number of items received against the carrier’s bill of lading. Inspect all
items for apparent damage. Immediately report any shortages or obvious damage to the
carrier and to your local RoboVent Representative, call the factory at
1-(888)-762-6836
,
or email:
customer.service@robovent.com
.
When all skids are completely unpacked and uncrated, check all items received against the
packing lists. Further inspect the unit and components for hidden damage. Again, report
any shortage or damage to the carrier and to your local RoboVent Representative.
The filter cartridges are typically shipped installed in your collector. Be sure to check them
for alignment, as they may have shifted during transit. If they have shifted, it is possible
that damage may have been done. Remove all filter cartridges and inspect thoroughly.
Note: Do not return any damaged components without first contacting your RoboVent
Representative to obtain a Returned Goods Authorization (RGA).
Small Parts
Carefully inspect all packing material before it is discarded, to be sure that no small parts
have been missed.
SECTION 300
Receiving & Inspection