RoboVent FlexPro Hi-Vacuum Series, Owner'S Manual, Page: 53 / 88

ROBOVENT • FLEXPRO HI-VACUUM SERIES OWNER’S MANUAL 53
SECTION 900
Maintenance
Motor Greasing
Motor bearing greasing frequency, type of lubrication
and amounts will vary depending on the type and
size of the motor in the unit. For more information,
please contact RoboVent Tech Support at (
1-888-
762-6836
) or email
customer.service@robovent.
com
. Motor manuals can be sent upon request. As
a general rule, RoboVent recommends greasing all
motors over 20hp once annually. (see Figure 35).
Fire Suppression Inspections
Dry Chemical: Monthly Inspection
Inspection by the owner or end user should verify the
following:
1. The Suppression Unit is in its proper location
as installed by the factory or factory certified
technicians.
2. The Manual Actuators are unobstructed.
3. The Suppression Unit shows no physical damage
or condition that might prevent operation.
a. This includes inspecting the detection tubing in
the hazard area for abrasion, distortion, cuts, or
dirt accumulation.
4. The Pressure Gauge is in the operable range. (see
Figure 36).
5. The Nozzle Blowoff Caps are intact and
undamaged. (see Figure 37).
6. Neither the Protected Equipment nor the Hazard
has been replaced, modified, or relocated.
FIGURE 35
FIGURE 36
FIGURE 37