Robotiq FT-150/300 Sensor
Instruction Manual
Robotiq inc. © 2016
16
3.5.1 Wiring with USB to RS485 converter
When using a RS485 to USB converter (see
), the wiring must respect
Spart Parts, Kits and Accessories section
Figure 3.5.1.1 and the following directions. GND / 0V is wired to Sensor pin #1 as stated in Section 3.5.
The converter will provide you with a standard USB 2.0 male A connector.
Warning
Power is not delivered via the USB,
.
do not plug 24V into the USB
Figure 3.5.1.1 : Wiring diagram for the different RS485 to USB converters delivered before & after April 2015.
