4 Mount
To mount the gimbal to your copter, add a mounting screw from below the gimbal to each of the
three holes in the gimbal interface plate indicated below. Add a spacer to each screw above the
gimbal plate, and attach the screws to the three holes in the lower body plate indicated below.
The spacers should be
between the gimbal interface plate and the lower body plate
.
gimbal interface plate
Y6 lower body plate
connect to
Quad/X8 lower body plate
gimbal interface
plate
lower body plate
Operating the gimbal
Start your flight by following the preflight steps described in your copter’s
manual and checklist.
Upon powering your copter, the gimbal will display a solid yellow light while
it is starting and calibrating.
Do not touch the gimbal while it is starting up.
When the gimbal displays a blinking blue light, it is ready to fly.
If the gimbal is not connected to the autopilot, it will perform automatic
stabilization without enabled transmitter control, indicated by a solid blue
light.
Calibrating, do not touch gimbal
Ready, connected to autopilot
Ready, not connected to autopilot
