®
Blixer 5V and
®
Blixer 6V Operation Manual
3
II. ASSEMBLY / DISASSEMBLY
INSTRUCTIONS
The unit comes from the factory completely assembled.
However, prior to use the machine should be cleaned
according to the cleaning instructions detailed in section IV. A
good working area should be chosen to operate the unit. The
motor base should be placed on a counter at a comfortable
working height, easy access, and have a standard 120 volt
power outlet available. ALWAYS KEEP THE MACHINE
UNPLUGGED DURING ASSEMBLY AND DISASSEMBLY.
Instructions for Assembly:
STEP #1. Place the bowl onto the motor base with the handle
turned off-center to your left. With the bowl fully seated and
level with the motor base, twist the handle back
counterclockwise until the bowl locks in place. The handle
should be centered over the front of the motor base and the
bowl should be level with the top surface of the motor base.
NOTE: The machine will not operate correctly unless the bowl
is fully seated and locked in pl
ace.
STEP #2. Place the blade on the motor shaft. It may be
necessary to rotate the blade until it falls into place on the
motor shaft. When the “S” blade is in the correct position the
lower blade should be resting just off the bottom of the bowl.
STEP #3. Insert the wiper assembly handle into the opening
in the top of the lid as in the picture. Using both hands, align
the tabs on the handle with the indentations on the wiper. Press
in and turn clockwise.
STEP #4. With the wiper assembly in place, put the lid on the
bowl. Note the three extensions on the lid. One is longer with
an arrow pointing to the right. Locate this extension just to
the left of the bowl handle. Then, with the lid fully seated, turn
the lid counterclockwise until it comes to a complete stop with
the long tab located over the bowl handle.
E. Blade Assembly/Disassembly
1. Unplug the cord, and wear cut-resistant gloves!
®
Blixer 5V
2. There is a removable cap in the top of the
®
Blixer 5V Blade. The
cap should be removed before cleaning. To remove the cap, push a
long blunt object such as a screwdriver, through the bottom of the
blade, and knock out the top cap.
®
Blixer 6V
1. Unplug the cord, and wear cut-resistant gloves!
2. Put the blade tool down over the motor shaft with the raised stop
facing the front of the machine.
3. Put the blade assembly on the motor shaft and onto the blade
tool.
4. Insert the metal bar into one of the holes in the blade cap.
5. Turn the blade cap clockwise to tighten or counterclockwise to
loosen. The bottom blade should hit the stop on the blade tool and
prevent the assembly from turning. Do not overtighten.