OPERATING WITH A CONTROLLER
Connect the Roboscan to the controller using the XLR/XLR or XLR/Dsub cable which
came with the controller.
If you are only using one Roboscan insert the terminating plug which came with the
controller into the unused XLR socket on the Roboscan.
If you are using other lighting units with the controller they should be connected
together with XLR/XLR cables. The order is not important - use an order which gives
the easiest and shortest cable routing. The last unit on the link should be terminated
with the terminating plug.
Set the DIP switch on the Roboscan to the desired controller channel as shown on
page 12.
Switch the Roboscan(s) on before you switch on the controller. A short start-up and
test routine will be performed (about half a minute).
Switch on the controller and program your show!
