29
Routine Maintenance
Robot Sensors
Use a soft, dry cloth to wipe and clean all sensors, including:
1. The dock locator and charging contacts in the front;
2. The wall sensor on the right;
3. The carpet sensor and six cliff sensors on the bottom;
4. The mop wash sensor in the rear.
Moving the Dock
To move the dock, grip the handle on the back with one hand and the
inner side of the front board with the other hand, as shown below. Do not
lift the base directly to prevent the dock from falling off.
Notes:
•
To prevent corrosion or damage, do not use cleaning fluid or disinfectant not specified by
Roborock in the water tank.
•
Do not use hot water as this may cause the tank to deform.
•
If any water stains remain on the outside of the water tank, wipe them with a soft dry cloth
before reinstalling the tank.
Water Tank
Clean the dirty water tank regularly as needed. Open the dirty water tank
lid and pour out the dirty water. Fill the tank with clean water, close the lid,
lock it, and shake. Pour out the dirty water. Close the lid and then re-install.
Carpet Sensor
Six Cliff Sensors
Dock Locator
Wall Sensor
Mop Wash Sensor
Charging Contacts
