
10
Note:
The dust bag handle seals the bag on removal to prevent
dust leakage.
C8-1—
Remove the dustbin cover vertically
as shown.
C8-2—
Lift the dust bag out of the dustbin
and discard it.
C8-4—
Install a new dust bag in place along
the slot and put the dustbin cover
back.
C8-3—
Clean the filter with a dry cloth.
C9
Air Duct
* Replace as needed.
C9-1—
Unscrew the screws (10) and remove
the cover.
C9-2—
Wipe the air duct and cover with a
dry cloth.
C9-3—
Re-install the cover and screw it
back in place.
C10-3—
Four Cliff Sensors
C10-2—
Wall Sensor
C10
Robot Sensors
* Clean every month.
C10-1—
Dock Locator
Use a soft, dry cloth to wipe all sensors,
including:
Basic Parameters
Robot
Note:
The serial number is on a sticker on the underside of
the robot.
< 6 hours
Charging Time
Q400RR
Model
14.4V/5200mAh
lithium-ion battery
Battery
Approx. 3.2kg
Weight
20V 1.2A
20V 1.2A
Rated Input
50-60Hz
Clean the charging contacts of the dock and
C11
Charging Contact Areas
The robot is equipped with a high-
performance lithium-ion rechargeable
battery pack. To maintain battery
performance, keep the robot charged during
normal use.
Battery
Note:
If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.
5A
Rated Input (Dust Collection)
Rated Output
Rated Input (Charge)
Auto-Empty Dock
AED03HRR, AED04HRR
Model
220-240V~
Rated Input Voltage
Rated Frequency
Errors
If an error occurs while the robot is cleaning, the
power indicator will flash red quickly, and a voice
alert will sound. Refer to the following table for
troubleshooting.
1. After resolving any of the following errors, relocate
your robot and restart cleaning.
2. After any sensor errors, clean the sensor and retry.
3. If the battery is at an abnormal temperature, wait
for it to return to normal before use.
Error 1:
LiDAR turret or laser blocked. Check
for obstruction and retry.
Error 2:
Bumper stuck. Clean it and lightly tap
to release it.
Error 3:
Wheels suspended. Move robot and
restart.
Error 4:
Cliff sensor error. Clean cliff sensors,
move robot away from drops and restart.
Error 5:
Main brush jammed. Clean main brush
and bearings.
Error 6:
Side brush jammed. Remove and clean
side brush.
Error 7:
Wheels jammed. Move the robot and
restart.
Error 8:
Robot trapped. Clear obstacles
surrounding robot.
Error 13:
Charging error. Clean charging
contacts and retry.
Error 9:
No dustbin. Install dustbin and filter.
Error 12:
Low battery. Recharge and retry.
Error 14:
Battery error.
* Clean every month.
Charging Battery
14.4V/5200mAh
lithium-ion battery
the robot with a soft, dry cloth.
0.5A