Robland KM 775, Instruction Manual

Page: 8 / 70

1
1 INTRODUCTION:
1.1 Purpose of the operating manual:
This manual is aimed at the operator and especially the personnel responsible for
using the machine correctly and thereby achieving good safety at work. It is, then,
recommended that the manual be read through carefully, paying particular attention to
the sections on warnings, precautions and methods of use, and that it is kept close to
hand for future reference, preferably next to the machine itself.
1.2 Presentation:
KM 775 edge banding machines are automatic machines equipped with a bottom
vertical gluing station, pressure rollers, front and back end trimming station, trimming
station, radius scraper, polisher and both top and bottom corner rounding station, as
well as a number of other features depending on version.
1.3 Reference standards:
KM 775 edge banding machines are designed and built in accordance with the
following standards:

Directive community: 2006/95/CE, 2004/108/CE, 2006/42/CE

Harmonized norms: EN 14121:2007, EN 60204-1:1999, EN 13849-1:2008, EN
953:1998, EN 1088:1996, EN 13850:2007
1.4 General warnings and recommendations:
Proper use of this machine involves perfect knowledge of these instructions for
use and of all the risks arising out of improper use. The machine must therefore only be
used by authorized personnel.
Safety when using this machine is only guaranteed for the functions and
materials specified in these instructions for use. ROBLAND accepts no responsibility in
cases where the machine has been used for purposes other than those indicated in and
complying with these instructions for use.
ROBLAND accepts no responsibility in matters related with machine safety,
reliability and performance in cases where the warnings and suggestions in this manual
have not been respected, in particular concerning the activities of erection and
assembly, use, routine and special maintenance and repair.
The electrical installation for the machine must comply with CEI 64.8 (CENELEC
HD 384-IEC 408) standards. The machine builder renounces all types of responsibility in