3
Push in the control knob slightly and turn it clockwise to the OFF position.
Ignition is by an electronic spark generator powered by a PP3 battery and operates to light the pilot. In the event of failure of the
electronic spark due to low battery etc. the fire can be lit with a match or taper.
First remove the front panel (see (a) below). Light the match or taper, place it near the pilot, turn the knob to the PILOT position
and press down to light the pilot. Keep the knob pushed in for 10 seconds before releasing. The pilot should remain lit.
Replace the front panel before turning the control knob to a higher position.
Depressing and rotating the knob clockwise from the full-on position brings you firstly to the 3 position. At this setting the centre
two radiants are bright and the outer two radiants are on low. The two outer radiants are extinguished by turning the tap knob to
the halfway 2 position. This position gives approximately half the full heat of the fire. Rotating the knob further in a clockwise
direction brings you to the 1 position. This gives you about 1/4 of the full heat of the fire and is the most economical setting.
(a) FRONT PANEL: The front panel is a one piece assembly and can be removed very easily. This is done by lifting the front panel
upwards to clear the lower support pins and then pulling outwards and downwards from the fire. When replacing care must be
taken to ensure that the top slots are correctly engaged before sliding the panel upwards and back into position on the lower
support pins.
N.B.: The four pins that support the front panel are fitted in the front of the slots in the metal case.
(b) RADIANT CHANGING: Before changing the radiant ensure that the fire is cold. Remove the front panel as described above.
The radiant is then removed by lifting upwards and outwards. When replacing the radiant ensure that the bottom of the radiant
is seated down and behind the raised front edge The makers part number for the radiant is 995 971 and the G.C. number is
154 371.
(c) REPLACING BATTERY: Remove front panel (a) above. Remove battery and replace with a new one.
Do not attempt to clean the heater while it is warm. Generally cleaning can be done with a damp soapy cloth followed by polishing
with a soft cloth.
Abrasive cleaners should never be used. The wood effect of the fire should be wiped with a damp cloth only. Do not apply
furniture polish to this case.
TO TURN OFF
LIGHTING WITH A MATCH OR TAPER
ECONOMY USE
CLEANING
SIMPLE MAINTENANCE
