5
Installation
5.
Connect and secure the ducting (use duct tape if required).
6.
Remove the protective plastic covering from all parts including the filters. Fit the canopy hood on the fixing
bracket. Mark and drill the two holes required for the safety screws. Secure the canopy in place with the safety
screws provided. The safety screws stop the canopy from accidently being knocked off the fixing plate.
7.
Insert the upper chimney piece into the lower chimney piece. Assemble the lower chimney bracket onto the
lower chimney using screws provided and ensure the bracket holds both chimney pieces. Do not fully tighten
the screws as some adjustment is required in step 9.
8.
Connect to the power supply and switch on the power to the canopy hood. Check the function of the canopy
hood. Connect and secure the ducting (use duct tape if required).
9.
Place the two chimney pieces onto the canopy top and secure the lower part to the canopy sides. Extend the
upper chimney to the ceiling and secure in place with two screws supplied.
Recirculation mode
1.
This unit can be installed to operate in recirculation mode where ducting is not a chosen/desired or practical
option. There are recirculation grilles fitted on each side of the upper chimney which allow the cleansed air to
return to the kitchen. Ensure that the side outlet grilles are not obstructed. Even a partial obstruction will
restrict the efficiency of the rangehood.
2.
Charcoal filters required if choosing recirculation mode.
