6
Installation
Reverse Door
Warning: This is a technical procedure and requires laying the product down and raising it again. It is
recommended only to be carried out by persons comfortable with technical procedures and who are
physically able to lift 15kgs of weight. If unsure use 2 people to lift the product.
*** ENSURE THE PRODUCT IS NOT CONNECTED TO THE ELECTRICAL POWER
WHEN CARRYING OUT THIS PROCEDURE ***
The product could be permanently damaged if this procedure is carried out with the refrigerator
operating. Any damage caused by not following all instructions in the procedure correctly could affect
the product warranty.
When working around cut sheet metal edges use appropriate gloves or protection to eliminate
the change of receiving a laceration.
Tools required: Philips screwdriver, Flat bladed screwdriver, Hexagonal spanner.
Ensure the unit is unplugged and empty.
To take the door off, it is necessary to tilt the unit backwards. You should rest the unit on
something solid so that it will not slip during the door reversing process.
All parts removed must be saved to do the reinstallation of the door.
Do not lay the unit flat as this may damage the coolant system.
It’s better that 2 people handle the unit during assembly.
1. Closed upper door, take out the screw from the top hinge covers by cross screwdriver.
Take off hinge cover, then unscrew top hinge and take off upper door.
Unplug the temperature sensor from inside the top hinge cover and put the sensor back into the unit as
shown below. Remove the door carefully and safely place to protect it from damage.