2
Installation Instructions
Unpacking the Appliance
•
Remove the external & internal packaging.
•
When unpacking the appliance please check for any damage. If damage is found, do not connect to the
power source and contact the Authorized Service Provider.
•
Before connecting the appliance to the power source, let it stand upright for approximately 4 hours. This will
reduce the possibility of a malfunction in the cooling system from handling during transportation. Remove
any protective film from the outer surface.
•
Clean the interior surface with lukewarm water using a soft cloth.
Location
The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight, etc.
Ensure that air can circulate freely around the back of the cabinet. Ensure the opening arc of the lid clears any
overhead obstructions. Ideally, the appliance should not be positioned below overhanging wall units. Accurate
leveling is ensured by one or more adjustable feet at the base if the cabinet.
Warning
: It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be
easily accessible after the installation.
Electrical Connection
Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic
power supply. The appliance must be earthed. The power supply cable plug is provided with a contact for this
purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in
compliance with current regulations, consulting a qualified electrician.
Appliance Overview
*Note: Number of baskets supplied depends on the chest freezer model purchased.
