Instructions on use - continued
Cooking guidelines
•Please refer to the information given on food packaging for guidance on cooking temperatures and times. Once familiar
with the performance of your appliance, temperatures and times can be varied to suit personal preference.
If you are using the fan oven function, then you should follow the information given on the food packaging for this
particular mode of cooking.
•Make sure that frozen foods are thoroughly thawed before cooking, unless the instructions on the food packaging
advise that you can “cook from frozen”.
•You should pre-heat the oven and not place food inside of it until the oven operating light has gone off. You can choose
not to pre-heat when using the fan oven mode; however you should extend the cooking time given on the food
packaging by approximately ten minutes.
• Before cooking, check that any accessories that are not required are removed from the oven.
•Place cooking trays in the centre of the oven and leave gaps between the trays to allow air to circulate.
•Try to open the door as little as possible to view the dishes.
•The oven light will remain on during cooking.
Replacing the light bulb
Turn off the supply of power to the oven by turning off the circuit breaker connecting it to the mains, or by removing the
plug if it is accessible;
Unscrew the glass cover attached to the lamp holder;
Unscrew the lamp and replace it with another high-temperature lamp (300
℃
) with the following characteristics:
Voltage:
AC220V-240V
Wattage:
25W
Socket:
E 14
Temperature rating:
300
℃
Remount the glass cover and reconnect the appliance to the power supply.
WARNING
:
Ensure that the appliance is switched off before
replacing the lamp to avoid the possibility of electric shock.
Disassembling/assembling the oven door
To make it easier to clean the inside of your oven, the oven door can be removed, by proceeding as follows (fig. 1-2):
•Open the door completely and lift the 2 levers “B” (fig.1);
•Now, shutting the door slightly, you can lift it out by pulling out the hooks “A” as shown in figure 2.
•To remove the inner glass, place the door handle down onto a clean, flat surface (like a towel on a table). Pull the glass
towards the top of the door, and then rotate (from the top) out. Once clean, replace glass in the door.
To reassemble the door:
•With the door in a vertical position, insert the two hooks “A into the slots;
•Ensure that seat “D” is hooked perfectly onto the edge of the slot (move the oven door backwards and forward
slightly);
•Keep the oven door open fully, unhook the 2 levers “B” downwards and then shut the door again.
8
Maintenance and cleaning