24
[Enter] button at the same time.
DMX In - DMX readout.
The menu is used to read DMX values of each channel received by the fixture.
Temp
-
Temperature
. The menu shows temperature in the LED module.
Current
- A current temperature of the LED module.
Highest
- A maximum temperature of the LED module since the fixture has
been fabricated.
High Res
- A maximum temperature of the LED module since the counter
was last reset.
In order to reset this counter, press and hold both [NEXT] and [PREV] buttons and the
[Enter] button at the same time.
Sw Ver
-
Software versions
. Select this item to read the software version of the fixture modules.
IC-1
- A zoom processor on the main board in the fixture arm.
IC-2
- A display processor on the display board in the fixture base.
IC-3
- LED control processor on the board in the fixture head.
6.6 Personality (Pers)
DMX Pres
-
DMX preset
. Use the menu to select desired channel mode.
Mode 1
- 32 control channels
Mode 2
- 16 control channels
Mode 3
- 10 control channels
Mode 4
- 5 control channels
Mode 5
- 32 control channels
Mode 6
- 37 control channels (equivalent to the LEDWash 300 in mode 1)
DMX In
-
DMX input
. Use the menu to select mode of receiving DMX signal.
Wired
- DMX signal is received by means of the standard DMX cable.
Wireless
- DMX signal is received by means of the inbuilt wireless module.
Display
-
Display adjusting
. This menu allows you to adjust the display behaviour.
Turn
- This function turns the display by 180°.
On/Off T
- This function allows you to keep the display permanent on or turn it off two
minutes after last pressing any button on the control panel.
Contrast
- Use this function to adjust contrast of the display (0-100%).
Backlight
- Use this function to adjust backlight of the display (0-100%).
C Cal M
-
Colour calibration mode
. If the function is on, the white output (2700K-8000K) from the fixture (and
also mixed colours) is more uniform. Each colour is dynamically corrected according to the value set in the
menu "Calibrate Effects" (Special-> Adjust-> Calib).
C Mix M
-
Colour mixing mode
. This item allows switching into RGBW or CMY mode. In the CMY mode, the
white(8bit)/white (16) bit channels are not active.
Mic Sens
-
Microfon sensitivity
. Enter the menu if you want to adjust the microphone sensitivity ( 1-max.,
19-min.).
Fans
-
Fan mode
. Use the menu to set the fixture fans to max. fan power mode ("
High
") or to auto- control
mode ("
Auto
").
Temp Uni
-
Temperature unit
. Use the menu item to change temperature unit from °C to °F.
I Ef Pos
-
Init effect positions
. Use the menu to set all effects to the desired positions at which they will stay
after switching the fixture on without DMX signal connected.
Defaults
- The menu item allows to set all fixture parameters to the default (factory) values.
6.7 Manual Control (Manual)
Pres Eff
-
Preset effects
. Use the menu to show preset positions of each channel effect.
Summary of Contents for Actor 3 ST
Page 1: ...1 Version 1 3 ...
Page 32: ...32 13 Photometric diagrams ...
Page 33: ...33 ...
Page 34: ...34 ...