Robin actor 12, User Manual, Page: 24 / 34

24
Current - A current temperature of the LED module.
Highest - A maximum temperature of the the LED module since the fixture has
been fabricated.
High Res - A maximum temperature of the the LED module since the counter
was last reset.
I n order to reset this counter, press and hold both [NEXT] and [PREV] buttons and the
[Enter] button at the same time.
Sw Ver - Software versions . Select this item to read the software version of the fixture modules.
IC-1 - A display processor 1
IC-2 - A display processor 2
IC-3 - LED control processor 1
IC-4 - LED control processor 2
6.6 Personality (Pers)
DMX Pres - DMX preset . Use the menu to select desired channel mode.
Mode 1 - 40 control channels
Mode 2 - 16 control channels
Mode 3 - 10 control channels
Mode 4 - 5 control channels
Mode 5 - 40 control channels
Mode 6 - 45 control channels (equivalent to the LEDWash 1200 in mode 1)
DMX In - DMX input . Use the menu to select mode of receiving DMX signal.
Wired - DMX signal is received by means of the standard DMX cable.
Wireless - DMX signal is received by means of the inbuilt wireless module.
Display - Display adjusting . This menu allows you to adjust the display behaviour.
Turn - This function turns the display by 180°.
On/Off T - This function allows you to keep the display permanent on or turn it off two
minutes after last pressing any button on the control panel.
Contrast - Use this function to adjust contrast of the display (0-100%).
Backlight - Use this function to adjust backlight of the display (0-100%).
C Cal M - Colour calibration mode . If the functin is on, the white output (2700K-8000K) from the fixture (and
also mixed colours) is more uniform. Each colour is dynamically corrected according to the value set in the
menu "Calibrate Effects" (Special-> Adjust-> Calib).
C Mix M - Colour mixing mode . This item allows switching into RGBW or CMY mode. In the CMY mode, the
white(8bit)/white (16 bit) channels are not active.
Mic Sens - Microfon sensitivity . Enter the menu if you want to adjust the microphone sensitivity ( 1-max.,
19-min.).
Fans - Fan mode . Use the menu to set the fixture fans to max. fan power mode (" High ") or to auto- control
mode (" Auto ").
Temp Uni - Temperature unit . Use the menu item to change temperature unit from °C to °F.
I Ef Pos - Init effect positions . Use the menu to set all effects to the desired positions at which they will stay
after switching the fixture on without DMX signal connected.
Defaults - The menu item allows to set all fixture parameters to the default (factory) values.
6.7 Manual Control (Manual)
Pres Eff - Preset effects . Use the menu to show preset positions of each channel effect.
Manual C - Manual control . Use the menu to control all fixture channels by means of the control panel.