12
Operating your radio - FM auto-tune
1. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so that it is as straight as possible extending
either above or below the radio.
2. Press the
On / Standby button
to switch on your clock radio.
3. Press the
Band button
to select the FM band.
4. Press and release the
Auto Tune button.
Your radio will scan from
low frequency to high frequency (or in the direction last scanned). It
will stop automatically when it finds a station of sufficient strength.
5. After a few seconds the display will update. The display will show the
frequency of the signal found. If the signal is strong enough and there
is RDS data present then the radio will display the station name.
Note that the radio will switch to the time display after 10 seconds if
no buttons are pressed.
6. To find additional stations press and release the
Auto Tune button
as before.
7. To scan the FM band in an opposite direction press and hold down
either the
Tuning Up button
(to scan low frequency to high frequency)
or
Tuning Down button
(to scan high frequency to low frequency)
and then press the
Auto tune button
again.
When the end of the waveband is reached your radio will recommence
tuning from the opposite end of the waveband.
9. Adjust the
Volume
to the required setting.
2
Auto Tune
Full
4,6,7
3
TUNING
SNOOZE
down
up
7
7
Summary of Contents for ecologic 5
Page 33: ...32 Notes...
Page 34: ...33 Notes...
