Using the Angle Setter
The unique Angle Setter allows the large tool platform to be set at any angle.
If a pre-set angle is required, for example 45
degrees (45˚), place the captive spanner over
the hexagonal locking bolt and loosen. Then
loosen the angle selection pin and move the
arm so that the selection pin locates into the
4th hole down from the top, as shown on the
Angle Setter guide
If a non pre-set angle is required, wind the
angle location pin back so that it is clear of the
location holes. Then position the tool platform
where it is required and tighten the locking
lever
The angle
selection pin in
the 4th hole from
the top, setting the
tool platform at
45 degrees (45˚)
The Angle Setter
with the angle
selection pin in the
top hole, which sets
the tool platform at
15 degrees (15˚)
11
