Con
fi
guration
Con
fi
guration
Plugging in and language selection
1. Place your sound system on a
fl
at surface and plug the cable from the mains
adaptor into the
DC input socket
located at the rear of your sound system
(marked 'DC in') ensuring that the plug is pushed fully into the socket.
2. If you wish to use a wired network connection, plug the Ethernet cable into
the RJ-45 socket at the back of the sound system.
3. Plug the mains adaptor into a wall socket and switch on the socket.
IMPORTANT:
The mains adaptor is used as the means of connecting the
radio to the mains supply. The mains socket used for the radio must remain
accessible during normal use. In order to disconnect the radio from the
mains, the mains adaptor should be removed from the mains socket outlet
completely.
4. When you apply power, the display on the sound system will light up and
say:
'ROBERTS'
and
'Stream 93i'
. After a few seconds the radio will then
enter Standby and the clock will display '00:00' as shown.
To continue to setup your sound system press and release the
On/Standby
button. If this is the
fi
rst time that you use your sound system (or after a Factory
Reset) the display will show
'Setup wizard'
and
'YES'
will be highlighted on
the screen.
5. By default your sound system will display all menus and messages in English.
If English is your preferred language then press the
Tuning/Select
control
to select
'YES'
and to begin setting up your sound system.
If you selected
'YES'
please skip to step 1 on page 10.
6. If your preferred language is not English, then rotate the
Tuning/Select
control so that the 'NO' option is highlighted. Press the
Tuning/Select
control
to enter the selection.
Continue on the next page.
Setup wizard
Start now?
8
5,6
Setup wizard
Start now?
4