Beam distribution (100W lamp):
Installing the fixture
The fixture has to be rigged to the truss or fastened to the floor stand via the mounting yoke only. The hole of
diameter of 12.2 mm in the yoke serves for screwing the yoke to the clamp or to the spigot (the spigot has to
be inserted into floor stand and secured).
Always check that the fixture is installed safely without a possibility to tilt it over.
Installing the lamp
Unplug from mains before installing the lamp!
Allow the device to cool approximately 30 minutes prior to manipulate with it
1. Unscrew four securing screws (1) and remove the front sieve cover (2).
2. Unscrew the lamp (3) from the socket (4).
3. Screw the new lamp to socket
.
Make sure that the lamp is installed tightly into the lamp socket. Do not install a lamp with a higher wattage
than stated in technical specifications of the fixture.
5. Place the front sieve cover (2) and screw the four screws (1).
3
