5
4. Setup
Remove all packing materials from shipping box. Check that all foam and plastic padding is removed.
Place machine on a fl at surface and remove hazer liquid tank cap.
Note the maximum liquid level mark located on the rear of the hazer.
Pour hazer liquid into the liquid tank, being careful not to exceed the maximum liquid level. DO NOT OVER-
FILL. Use only ROBE hazer liquid or other dealer-recommended high-quality hazer liquid. Any other types of
liquid can damage the unit. When liquid level reaches the fi ll line, place cap back on liquid tank.
Your hazer may be operated with or without a remote controller. If you will be controlling your unit remotely,
fi rmly attach the remote control cable to the proper input.
5. Operation
Plug power cord into a grounded electrical outlet.
To operate without remote control, simply turn hazer on. Haze emission will begin automatically.
To operate via remote control, press the appropriate button on the remote to begin haze emission.
For further information on operating your Haze 400 FT, see the section titled, ”Remote Control Operation”.
If your model includes a mounting bracket designed for overhead installation, it may be installed at fl oor level
or suspended overhead. If the unit is to be mounted using the bracket, avoid suspending the unit such that
haze is emitted directly toward any one’s face. Whatever installation method you choose, do not allow the unit
to have more than a 15 degree angle of inclination.
Important.
Always monitor tank liquid level during operation.
Running a hazer with no liquid can permanently damage the unit!
If you experience low output, mechanical noise or no output at all, unplug immediately. Check liquid level, the
external fuse, remote connection, and power from the wall. If all of the above appears to be O.K., plug the unit
in again. If hazer does not function after 30 seconds, discontinue operation or permanent damage to the unit
may result. Return the machine to your ROBE distributor. Always drain tank before mailing or transporting
this unit.
6. Remote Control Operation
Haze 400 FT uses 10 meter wired multi-function remote controller with 1⁄4” stereo plug . Press the red POWER
button to activate the remote control. Press the yellow TIMERS button to activate the timer function. Adjust the
interval between each haze emission (within the range of 10 seconds to 5 minutes) by means of the INTER-
VAL control knob. Adjust the duration of each haze emission (within the range of 1 to 90 seconds) by means
of the DURATION control knob. When pressed, the green MANUAL button activates the hazer, overriding all
other function controls.
7. DMX Operation
The Haze 400 FT has onboard DMX control. Currently, it uses 1 channel to control output operation. The DMX
channel is set on the back panel of the Haze 400 FT by setting the dip switches to the desired channel:
If Channel has a value from 0 to 5, the unit is OFF. Between the values 6 to 255 the Haze 400 FT produces
haze.
Examples:
