DMX start address setting
The DMX start address, is the first channel used to receive instructions from the DMX controller. The address
may be any channel from 1 to 510 and is set on the Address DIP switch.
Examples
Control mode setting
The last three DIP switches define control modes.
DIPs
Control Mode
10
11
12
Function
24 CH Intelli�lex Mode
OFF OFF OFF
Uses 24 Channel Personality to control each Halo Ring.
Uses Start Address for first port as defined by DIP's1-9.
Each subsequent port is 24 channelsLater.
3 CH Strobe Mode
ON
OFF OFF
Uses 3 Channel Strobe Personality to control each Halo
Ring.
Uses Start Address for first port as defined by DIP's
1-9. Each subsequent port is 3 channels Later .
3 CH RGB Mode
ON
ON
OFF
Uses 3 Channel RGB Personality to control each Halo
Ring.
Uses Start Address for first port as defined by DIP's
1-9. Each subsequent port is 3 channels Later .
Direct Mapping Mode
OFF
ON
OFF
Pixel Map each Halo Ring using 72 Channels.
Uses Start Address for first port as defined by DIP's
1-9. Each subsequent port is 72 channels Later .
Intelli-Mappping Mode
X
X
ON All 6 ports use the same 24 Channel Personality.
When Pixel Mapping Engine is active,it will work in a simi
-
lar way to the direct mapping map, but will start the map
25 channels later that the start address (72 Channels per
Port).
X = position ignored
ALWAYS DISCONNECT THE HALO DRIVER FROM MAINS BEFORE SETTING THE DIP SWITCHES.
Summary of Contents for HALO Driver
Page 1: ...Preliminary version ...
