25
-
- Fixture code
The option contains identification code (1-9999) for the fixture, which is used for the master/slave operation.
- Adjusting the default position of the colour wheel
By this function you can calibrate and adjust the colour wheel to its standard/right positions. Use the [ ] and [
] buttons to browse through the adjusting menu - the display shows step by step these messages: "PAn,
tilt,FPAn,FTilt,SPEd,Colo,b.out, FCAL" by which you can adjust the fixture to the required/desired position (0-
255) before the function calibration. Then when the positioning is finished use the last "F.CAL." function (Fixture
calibration).
1. Calibration via the control panel
Press [ ] and the [ ] or [ ] buttons in order to display the message: "Colo" for very smooth function
calibration. Press [ ] and use the [Up] and [Down] buttons in order to adjust its right value from 0 to 255. Then
press [ ] to confirm or [ ] to cancel and return to the menu. When the calibration is finished, it is necessary to
use the "A.rES." function in order to write the calibration value to the memory (EPROM) and to make a reset in
order to check the newly adjusted position of the colour wheel. When the reset of the fixture is finished, the display
will show the "F.CAL." message. Press [ ] to repeat the calibration or [ ] to return to the "AdJ." menu.
2. Calibration via the external controller
Connect the DMX controller, press [ ] and the [ ] or [ ] buttons in order to display the following message
"Colo" and press [ ].
Now you can calibrate the colour wheel by your controller. The DMX calibration protocol is described in the table
mentioned below.
DMX Calibration protocol: