6
Colour Wheel Moving ---
This function closes the light output during colour wheel /wheel
changes.
IR Sensor
--- Select this function to switch on/off infra-red remote control
.
Init Effect Positions
--- Select this function to set all effects to the desired positions.After switching the fixture
on (if DMX is not connected),all effects will move to this init positions.
Note:
If you operate e.g. 22 channels pre-setting (Mode 1) and you adjust DMX values for channels which are
not included in this mode,you will not be able to change these effects from the controller !
Default Settings
--- Select this option to reset all fixture personalities to the default values.
8.4 Lamp On/Off
Use this option in order to switch on/off the lamp.It is also important to note, that the lamp is cold restrike type,
that means, that it has to be cold before striking.
8.5 Test sequences
Use this menu to to run a special demo-test sequences without an external controller, which will show you
some possibilities of using ColorWash 575E AT.
Mode 1
--- This mode is suitable for projections on the wall, ceiling or ground without any
head movement.
Mode 2
--- This mode uses all ColorWash 575E AT functions including pan/tilt movement
and therefore is good for a complete introduction of the fixture.
8.6 Manual mode
Presetted Effects ---
Select this menu to call up presetted positions of channel effects.
Manual Effect control ---
Select this menu to control channels by control elements on the control
board.
8.7 Stand-alone setting
Use this menu to set options for stand-alone mode as a selection of the playing program,programming and
modifying current programs.
Music Trigger
--- Select this function to enable the sound control of the running programs via the
built-in microphone.
Presetting Playback
--- This function allows you to select the program which will be played in the
stand-alone mode after switching the fixture on.Selected program will be played continuously
in a loop.
Disabled
--- The option disables “Presetting playback” function.
Test Program
--- The option will start built-in test program.
Program 1
--- The option will start created program No.
Program 2
--- The option will start created program No.
Program 3
--- The option will start created program No. 3
Note:
If the fixture operates in the controller mode ( DMX controller is connected) and any program from this
menu is selected ,in this case the fixture will not respond to the DMX controller after switching on and will play
selected program.
Playing program
--- Select this menu to run a bilt-in program or the 3 freely-programmable
programs in a loop.
Test Program In Loop
--- The option starts built-in test program.
Program 1 In Loop
--- The option starts created program No.
Program 2
In Loop --- The option starts created program No.
Program 3 In Loop
--- The option starts created program No. 3
Select the program you wish and press [ENTER].The selected program starts running.By Pressing [ENTER]
again is possible to pause the program running.
Editing Program
--- Select this menu to edit or create the program.The ColorWash 575E AT has one built-in
Summary of Contents for Color Wash 575E AT
Page 1: ... Version 1 5 ...
Page 35: ...35 ...
