Robe Color Spot 575AT, User Manual

Page: 22 / 33

22 23
ColorWash 575 AT has been powered on since the counter was last reset.In order to
reset this counter to 0 you have to hold [UP] and[DOWN ] and press the [ENTER].
LA.St.
---
Lamp strikes
.Select this submenu to read the total number of the lamp strikes.
totL
--- The function shows the total number of the lamp strikes since the ColorWash
575 AT has been fabricated.
rSEt
--- The function shows the number of the lamp strikes since the counter was last
reset.In order to reset this counter to 0 you have to hold [UP] and[DOWN ] and press
[ENTER].
tEMP --- Fixture temperatures .Select this submenu to read the fixture temperatures (°C).Please note that the
outside temperature should not exceed 40° C.
Cur.t. --- Current fixture temperatures .
boAr. -Current temperature on the main board in the base of the
fixture.Temperatures above 66°C lead to the lamp being switched off
and the fixture goes to "low power mode".Before switching the lamp on
again (after 5 minutes),run a total fixture reset.
HEAd -Current temperature of the head inside.Temperatures below 66°C
are not critical. 66° C and more lead to the lamp being switched off and the
fixture goes to "low power mode".Before switching the lamp on again (after
5 minutes),run a total fixture reset.
Hi.tE.
---
Maximum fixture temperatures
.
boAr.
- The function shows the max.temperature on the main board since
the ColorWash 575 AT has been fabricated.
HEAd
- The function shows the max.temperature of the head inside since
the ColorWash 575 AT has been fabricated.
rSEt --- Maximum resetable temperatures.
boAr. - The function shows the maximum temperature on the main board
since the counter was last reset.In order to reset the counter to 0 you have
to hold [UP] and[DOWN ] and press the [ENTER].
HEAd - The function shows the maximum temperature of the head inside
since the counter was last reset.In order to reset the counter to 0 you have
to hold [UP] and[DOWN ] and press the [ENTER].
DM.In.
---
Readout of DMX values
.Select this function to read DMX values (0-255) of each channel received
by the fixture.
PAn
a coarse pan movement
C.SPd.
a CMY/CTC/dimmer speed
F.PAn
a fine pan movement
Macr.
a CMY macros
tilt
a coarse tilt movement
EFFE.
an effect wheel
F.tilt
a fine tilt movement
EF.ro.
a beam shaper rotation
SpEd a pan/tilt speed F.E.ro. a fine beam rotation
P.t.SE. a pan/tilt macro selection Zoom a zoom
P.t.SP. a pan/tilt speed F.Zom. a fine zoom
Func. a special function Stro. a strobe,shutter
Colo. a colour wheel dimr a shutter,strobe
F.Col. a fine colour wheel F.dim. a fine dimmer
CYAN a cyan lamella
MAGE. a magenta lemella
YELL.
an yellow lamela
CtC.F.
a CTC filter
VErS.
---
Software version
.Select this function to read the software version of processors:
IC1.b.
--- Main processor on the main board in the fixture base
IC2.b.
--- Pan processor on the main board in the fixture base
IC3.b.
--- Tilt procesor on the main board in the fixture base
IC4.b. --- EEprom on the main board in the fixture base
IC1.L. --- Processor 1 in the left arm of the fixture
IC2.L. --- Processor 2 in the left arm of the fixture
IC1.r. --- Processor 1 in the right arm of the fixture