Eminere UV
6
The Eminere UV is equipped with auto-switching power supply that automatically adjusts to any 50/60Hz AC power
source from 120-277 Volts.
The following wiring of the input/output connectors applies to the fixtures marked
X
on their labels only. Older
versions of the Eminere UVs have swapped D- and D+ and do not have mark
X
on their labels.
E.g.
Input
- panel connector
Output
- panel connector
(front view)
(front view)
Fixture´s Amphenol connectors are dust and water protected according to IP 67 by mating with related Amphenol
connectors.
They cannot stay disconnected outdoor.
The output panel connector at last fixture in the Eminere UV chain has to always be covered with the water-tight
cap to keep declared IP rating.
The Eminere UV modules should be connected to the E-box which allows power supply of the Eminere UV modules
and their control.
Do not connect (disconnect) Emineres UV to the E-box or Booster box and each other when they are under
voltage!
When you change any setting of the E-box, disconnect the E-box from power and connect it to power again
to activate changes which you have made.
Examples of connection for various versions of the E-box.
Please read the E-box user manual for more information about its setting and connection to Eminere UV modules.
Needed cables are stated in the chapter “Technical information“.
E-box Daisy
